SG350 VLAN Routing and Default Gateway Cisco Community

Cisco Ip Default Gateway. How to configure default route in cisco packet tracer YouTube So ip default-gateway tells the device "Hey, to communicate with someone outside this network, send your frames to x.x.x.x" The other command that does the same thing but on routing capable device is ip default-network. Use the ip default-gateway command when ip routing is disabled on a Cisco router

You provide the default gateway as the management interface SVI on SW1 or SW4 based on where in the network you are located My question is why we still need to use command ip default-gateway since the router still can reach the switch from other network without the ip default-gateway.

Solved Two isp connections in one nat network in one router Cisco

So ip default-gateway tells the device "Hey, to communicate with someone outside this network, send your frames to x.x.x.x" The other command that does the same thing but on routing capable device is ip default-network. The supervisor engine sends IP packets destined for other IP subnets to the default gateway (typically a router interface in the same network or subnet as the switch IP address) !--- For example, if the router is in boot ROM mode..

DefaultGateway vs Cisco YouTube. You provide the default gateway as the management interface SVI on SW1 or SW4 based on where in the network you are located on L3 devices if you decide to turn off routing on such device

DefaultGateway vs Cisco YouTube. Software Configuration Guide, Cisco IOS Release 15.2(2)E (Catalyst 2960, 2960-S, 2960-SF and 2960-Plus Switches) -Assigning the Switch IP Address and Default Gateway Use the ip default-network or ip route 0.0.0.0 0.0.0.0 commands to set the gateway of last resort on Cisco routers that have ip routing enabled